RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Tankhobby
Showing results 1 to 6 of 6
Search took 0.01 seconds.
Forum: RC Tanks
11-23-2019, 08:22 AM
Replies: 20
Views: 5,226
Posted By Tankhobby

Follow the input from the antenna. You would need...

Follow the input from the antenna. You would need an oscilloscope to track the signal.
At this point the only practical solution would be to have a working board and compare signals/voltages. You...
Forum: RC Tanks
11-16-2019, 11:47 AM
Replies: 20
Views: 5,226
Posted By Tankhobby

The "reciever" section of the circuitry could be...

The "reciever" section of the circuitry could be bad. So there should be a single signal from the antenna that is read and then all the controlled outputs are separated from that. If the board has...
Forum: RC Tanks
11-16-2019, 11:44 AM
Replies: 20
Views: 5,226
Posted By Tankhobby

One of the IC's might have blown or failed. I had...

One of the IC's might have blown or failed. I had an IC that blew it's bottom out, literally. I traced the problem to that chip and when I desoldered it the bottom of it was cracked and burned,...
Forum: RC Tanks
11-16-2019, 10:42 AM
Replies: 20
Views: 5,226
Posted By Tankhobby

NICE! I might need one of these.

NICE! I might need one of these.
Forum: RC Tanks
11-16-2019, 10:41 AM
Replies: 20
Views: 5,226
Posted By Tankhobby

If you have a voltmeter: Test voltage between...

If you have a voltmeter:
Test voltage between B+ and B- with battery connected, disconnect the battery it and measure the battery voltage, if there is a large difference in value the board is...
Forum: RC Tanks
11-16-2019, 06:17 AM
Replies: 20
Views: 5,226
Posted By Tankhobby

Fixing a PCB without a schematic is tough. I've...

Fixing a PCB without a schematic is tough. I've attempted that a few times but now with surface mount and proprietary programmed parts it very tough. I would guess there may be a common failure mode...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.